I’ve been wanting make this bracelet holder for such a long time ever since I saw it on Kinky DIYctator. So after I read it, I immediately started collecting toilet paper rolls but something always happened to them. Either someone in the house thought it was trash and threw them away. Severally. Or maybe one would drop and I would mistakenly step on it. You get the picture? Tragic always followed those precious precious rolls. I eventually collected enough to make a bracelet holder and they just used to lay on my table. So everyone who stepped into my room always asked what they were for and I always gave them a vague answer. So mum, dad, Jeff and Finny, now you know! 🙂
I eventually ended up not using the toilet rolls I collected but one long roll used for kitchen paper towels.
What you need:
One long kitchen roll or toilet paper rolls glued or sellotaped together
Scissors or Seam ripper
Step 1: Make a hole at the center of the roll either using a seam ripper or a pair of scissors and stick it to the CD-holder stick using either glue or sellotape
Step 2: In an open air environment, spray paint the whole structure and leave it to dry for a while
Step 3: Worry no more about where to put your bracelets/bangles cause you just made your own bracelet holder!
P.S Make sure you balance the two sides!
Thanks for reading,